LINE-X Spraying Process
LINE-X is a two part polyurethane elastomer system. It uses equal parts of an "A" component or hardener and a "B" component or resin. When combined properly it produces a polyurethane elastomer similar to the bottoms of your work boot. The two liquid components are brought together (using special equipment) at the tip of the spray gun. LINE-X cures or "sets up" in 3 to 5 seconds, giving it an immediate set time.

Spraying Process:
  1. On a clean, dry truck, the bed is masked as if it is to be painted.
  2. The entire truck is covered to protect from over spray.
  3. The bed is wiped with a grease and wax remover, scuffed...and it's spray time!
  4. Sprayed on, it dries in 3-5 seconds. It's ready for heavy use (shoveling out gravel) in 24 hours.
  5. Immediately after spraying, the truck is unmasked.
Product Details:
  • Sprayed onto your truck bed up to 1/4" thick.
  • 100% bond to virtually any surface.
  • Best looking.
  • Environmentally safe - no VOCs or CFCs, 100% solids.
  • EPA exempt.
  • 80%+ physical properties to -50°
  • Withstands temperatures as high as 350° +

From start to finish it took less than 2 hours to complete the job. The truck is ready for use immediately - even in the rain or cold, without affecting the bed liner. We recommend 24 hours "set time" before placing heavy object on the bed.

LINE-X exhibits the highest tensile strength, the highest tear strength, and the highest abrasion resistance than any other spray-in liner available. This makes LINE-X the highest performing bed liner.

More Photos:
Truck Photos
Trucks		 Graphics
Graphics		 Other Uses
Other Uses
Cleaned Truck Bed
Cleaned - Scuffed
Taped Truck Bed
Taped - Covered
Spraying Truck Bed
Spraying
Protected Truck Bed
Protected
LINE-X Shortcuts